金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上

Pipe bending machine Pipe bending machine

Pipe bending machine

Intermediate frequency pipe bending machine PLC control system: adopting Siemens S7-200, using industrial computer or touch screen, according to the bending process, the required bend geometry size, bending radius, bending Angle and the number of raw materials, materials, the temperature needed for soups and a series of data input computer, let computer automatic tracking control according to the data, completing the process of heat pipe operation

(1) The medium frequency pipe bender adopts far infrared thermometer to sample at one point or several points. One point ensures reliable temperature rise, which is clearly displayed in the process and monitored at any time.(2) Automatic tracking control of medium frequency pipe bender: high network voltage, fast temperature rise, and fast hydraulic propulsion;The network voltage is low, the temperature rises slowly, the hydraulic propulsion speed is automatically slow, forming a closed loop and maintaining a relative balance.(3) the bending and simmering process of medium frequency pipe bender: the computer records the bending and simmering situation at any time.When the simmering Angle of an elbow pipe is in place, the computer automatically stops the machine and gives an alarm. The data and images of the whole simmering process can be stored and printed.

The structure of the pipe bender is as follows

(1) Mounting of the wheel models: a. Remove the fixing nut of the wheel models (FIG-7(1) in a counterclockwise direction.B. Put in the wheel mold, and then lock the fixing nut of the wheel mold.

(2) Clamp DIE

Installation: a. Pull out the clamping die and fix the centering shaft (FIG-7 (2)).B. Put the clamping die in, and then insert the fixed mandrel.

Adjustment: a. Fix the clamping mold seat (FIG-7 (3)) and relax it. Then put the control panel in manual mode and press the clamping button (FIG-7 (3) to the end of the clamping mold path.(At this time, there needs to be a gap between the clamping die of the wheel mold, and the clamping die seat can be adjusted by adjusting the screw (FIG-7 (4)).

B. Adjust the clamping mold seat and the adjusting screw (FIG-7 (4)) to make the clamping mold and the wheel mold fully close.

C. Press the backclamp button (FIG-4 (6) to make the clamping mold back, and then rotate the clamping mold adjusting screw (FIG-7 (4)) about 1/2 to 1/4 turns clockwise.

D. Then lock the fixing nut of the clamping die seat (FIG-7 (3)).

(3) Guide mold (PRESSURE DIE)

Installation: a. Remove the guide mold fixing screw (FIG-7 (8)), and then put the guide mold in.

B. Tighten the guide mold screws.

1652-1640.