金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上

How the customer sees the pipe bender

How the customer sees the pipe bender  

What does the pipe bender look like in the customer: it should be the equipment that produces the elbow.  However, customers need to pay attention to the following when using the pipe bending machine:  

Bend, first remove floating rust and dirt on the surface of the steel tube bending, will bend the pipe with the specifications of the pipe clamp is installed on the derrick, and adjust the chuck center to the required position, bending radius to be fixed, and then, adjust the position of the support roller turn arm shaft was bent pipe center to center distance is equal to the bending radius.  Adjust the position of the supporting roller so that the distance from the center line of the bent pipe to the center of the tumbler shaft is equal to the bending radius.  Adjust the height of the supporting roller and bracket, so that the center line of the elbow and the center of the collet in the same plane, and parallel to the plane of the jib, the steel pipe through the heating ring?  And clamped in the chuck, adjust the heating ring, so that its inner and steel tube shell clearance consistent.  Turn on if heater when tube is heated to 950?  1000℃ (orange), immediately start the motor to bend the pipe, open the cooling water valve at the same time, spray water to the local position cooling.  When bending the pipe, if the temperature of the pipe is too high, the rotational speed of the arm can be properly accelerated.  Otherwise, the rotational speed of the rotating arm is slowed down to keep the heating zone of the steel tube at the same temperature.  When bending to the required Angle, stop heating, stop the motor at the same time, and water to continue cooling, so that the bending pipe cooling to room temperature.  Take out the elbow and check whether the bending Angle and quality meet the requirements.  

The above is the company introduced the pipe bending machine in the use of matters needing attention, hope to use the customer can slowly understand the pipe bending machine.