金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上

What problems will occur during the production of the pipe b

What problems will occur during the production of the pipe bender

Pipe bender is one of the commonly used pipe fitting equipment in product processing. With the pipe bender in the project can be completed efficiently, not only can improve the production efficiency, but also the error of the pipe bender in the production of pipe bending is reduced a lot.One of the common failures of the pipe bender is the noise, and the reason for such a problem is common, is that the gap between the slider and the guide rail of the pipe bender is too large.Once a similar situation occurs, the first thing to consider is whether the guide plate should be replaced, and the spacing of the guide rail should be re-adjusted to achieve the best condition.The advantages of the pipe bender are very obvious, but the pipe bender is not perfect to the point of no failure.

The pipe bender in those problems will:The first is to check the cartridge valve pipe bender, see step aside whether be jammed, if it is can be removed as long as is clean, but it is also possible because of pipe bender slider back so quickly, so the problem is that liquid valve, if there is also a system that is used by the pipe bender is the loss of pressure system, so afraid of meetBut since it has already happened, it is necessary to find out the cause quickly and solve it in a targeted way.The above is the introduction of Borders problems that need to be solved in time.

Heating mode and composition of medium frequency pipe bender

The intermediate frequency pipe bender is used for the forming of the bending pipe, the main power of the intermediate frequency pipe bender is the hydraulic cylinder, the heating method of the intermediate frequency pipe bender is the intermediate frequency heating (in addition to the use of gas and natural gas heating) the diameter of the bending pipe is 21mm-1620mm,The wall thickness of the intermediate frequency pipe bender is 3mm-120mm. The intermediate frequency heating of the intermediate frequency pipe bender is regarded as the pipe bender is used for the bending of carbon steel and alloy steel.If it is other material, we can customize it according to customer's requirements.

Medium frequency pipe bender mainly includes: base, main cylinder support plate (including main cylinder), movable push plate, elbow clamp wheel platform.Bend rocker arm, rocker arm shaft.The elbow forms the clamp.The intermediate frequency transformer bracket, intermediate frequency power supply, intermediate frequency transformer, electrical control system and so on.

The heating method of intermediate frequency pipe bender in the production of bending pipe is mainly intermediate frequency heating coil.The type and material of the pipe bender are directly customized according to the needs of customers.

2107-2101.