金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上

Pipe equipment

Pipe equipment

Pipe fittings equipment is the production and sales in one of the medium frequency induction complete sets of equipment and pipe bender, elbow machine, tee machine, pipe expansion machine and other professional manufacturers.The pipe fitting equipment is designed and manufactured for large caliber pipe engineering and for the growing market demand of various specifications of pipe bending.

The bending radius and Angle of the required bending pipe can be adjusted according to the needs of users.

The equipment is made of seamless steel pipe, welded steel pipe or rolled steel pipe.

Push bending pipe specifications: outside diameter: Φ108 ~ 1420mm, wall thickness: Φ5 ~ 100mm,

The bending radius of the bending pipe is more than 3D, and the Angle of the bending pipe can be adjusted freely within the range.

The stroke of the main oil cylinder is determined according to the diameter and bending radius of the steel pipe (provided by the user).

Pipe fitting equipment mainly includes: frame, main cylinder support plate (including main cylinder), movable push plate, elbow clamp wheel platform, elbow rocker arm, rocker arm track, rocker arm shaft, elbow combination chuck, intermediate frequency transformer bracket, intermediate frequency power supply, intermediate frequency transformer, electrical control system and so on.

Production of induction ring of pipe fitting equipment

Material selection with diameter of ￠6 above (wall thickness of 1mm is the best) copper tube, > diameter of more than 10mm of copper tube is the best choice of copper tube winding.

The copper tubes are annealed before being wound, then smashed flat at one end and filled with fine sand or liquid lead.

According to the design of the induction induction ring shape gradually bend beating shape, it is best to use a wooden hammer when beating, turning should be slow beating should not be too hard.

After bending, with fine sand shake out your circle of brass knock, and lead the liquid should be heated to induction coil, lead melts will lead liquid poured out, check whether the induction coil, ventilation, for more than ring structure of the induction coil to prevent interturn know road should be put on high temperature resistant insulation materials (such as glass fiber catheter, or glass fiber tape, etc.), connected to the machine of the electrical contact surface oxide layer should be clean,Ensure good contact.

If there are special process requirements of the induction ring, please contact the factory or professional personnel!

1934-1924.