金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上

The most important points to pay attention to before and aft

The most important points to pay attention to before and after the use of the beveling machine:

Before starting the beveling machine, it should be checked that the operation area can not affect the operation of the machine.The operator's hands and body and other parts should be far away from the range of tool rotation. Before starting, the blade should not touch the pipe mouth, and the distance is 1-2mm.

Check whether the beveling machine itself is in good condition and whether the specifications of the beveling machine are consistent with the size of the pipe processed.Whether the size of the fixed block assembled on the beveling machine is consistent with the size of the pipe, whether the outer surface of the clamping part on the pipe is smooth, whether there are raised thorns or sticky debris.If there should be removed after the first.

Check whether the beveling mechanical and electrical source is in good condition. If the insulation layer is damaged, it should be dealt with first.The beveling machine shall install the beveling knife when the power supply is disconnected.The specifications of the tool should meet the requirements of the beveling, the tool tip should exceed the outer diameter of the pipe about 2-3mm, the blade part is appropriate from the pipe end 1-2mm, remember not to put the beveling knife installed in reverse, the blade can not have a gap.

When the beveling machine is transferred to the pipe, the clamp is reliable and cannot be loosened.It is strictly prohibited to use extended casing force, otherwise it will deform the casing too much, affect the verticality of the groove surface, or even damage the casing and scrap it.

When the machine stops after use, first disconnect the power switch and unplug the plug.Loosen the compression screw to separate the beveler from the pipe.Remove the tool, clean the machine, put it back for use.The above briefly introduces the matters needing attention before and after the use of the groove machine.

1843