金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上

The economic reform brought to customers by pipe bending mac

The economic reform brought to customers by pipe bending machine manufacturers  

 We need to use the technology of bending pipe processing in a lot of machinery manufacturing, so is there any understanding of it now?  Below we first from some aspects to a simple understanding.  

The large-caliber pipe bend is a common pipe fitting used in long-distance pipeline construction. It is made by vertical hydraulic pipe bender on the spot according to the actual direction of pipeline and the required bending Angle.  Into the 21st century, the long distance pipeline engineering construction in China has developed rapidly, and China's complex and varied landscape, pipeline along the mountain hills, plains, more the demand of cold bending tube is quite big, but as a result of many who took part in the construction unit lacked the experience in the production of cold bend, on how to create a high quality of cold bend, is still at groping stage.  As a manufacturer of pipe bending machine, in the process of development, test and application of pipe bending machine, we have conducted in-depth research and test on how to ensure the quality of pipe bending, analyzed the common defects of pipe bending and put forward control measures for reference.  Each bend is made several times.  Steel pipe in the pipe bending machine, pipe bending machine for steel pipe bending moment, a moderate amount of deformation in the steel pipe local, form a certain Angle, the purpose of bending, the basic process is: the back-end fixture clamping steel tube, and then through the front lower die upward movement on the support of the main oil cylinder, make steel tube along the central curve bending deformation of upper die, until the bending type.  The deformation of steel pipe occurs on the upper die, which acts as a die, and its curve is determined according to the critical value of plastic deformation of steel pipe with different specifications and materials.  Lou used different steel tubes for different upper dies.   According to the cause of wrinkles, we control from two aspects: on the one hand, in the bending process, the inner tube should not be placed on the side near the front fixture, but should be placed on the side near the bending cylinder of the lower die, and the rear of the inner tube is about 150mm beyond the rear of the upper tube.  At the same time, the lift of the bending cylinder should not be too large during the first three times of bending. In the subsequent process, the lift of the bending cylinder should gradually increase until the steel pipe contacts the highest point of the upper tire arc, so that the steel pipe can smoothly transition in the bending process and ensure that the steel pipe does not have unstable deformation.  On the other hand, adjust the inner tube before bending the steel pipe. When bending the first tube, the inner tube must be in a self-locking position, and bending can be carried out after supporting the inner wall of the steel pipe.  By taking the above measures, it can ensure that the steel pipe does not appear wrinkles.  

 In bending, we found that the axial position of the inner tube was not easy to control, so we designed and made a positioning car, and used a pole to connect the inner tube with the car rigidly.  When the center line of the inner tube and the upper die overlap, write down the relative position of the car, a bending operation to steel tube to the rear axle to move the machine, together with the inner tube and the car move back length a homework, and then loosen the inner tube expansion mechanism, launch tube motor, make the inner tube, together with the car to move forward, until the car back to the original position calibration.  In order to control the verticality of the inner tube, we used the indicating pointer, fixed it on the connecting pole, and marked the position mark at the tube mouth. When the indicating pointer was deflecting, the inner tube was pulled out in time and manually corrected.