金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上

Is this how you operate the elbow press?

Is this how you operate the elbow press?  

Elbow push machine operation process:  

First, do it carefully before operation  

1. The machine tool must be well grounded, and the conductor shall not be less than 4mm2 copper flexible wire.  Do not access the power supply voltage exceeding the specified range, do not plug plug-in live, do not use megohm meter to test the control loop, otherwise the device may be damaged.  

2. When inserting and unplugging connectors, do not pull out wires or cables to prevent welding pulling off.  

3. Proximity switches and encoders can not be hit with hard objects.  

4, can not use sharp objects collision display unit.  

5, the electrical box must be placed in a ventilated place, prohibited from working in dust and corrosive gas.  

6. Do not install or change the PC input and output terminal without permission.  

7. When changing the power supply of the machine tool, the motor must be reconfirmed.  

Bend machine  

8, the machine should be kept clean, special attention should be paid to clamping block, slide block and other sliding groove should not have foreign bodies.  

9. Add lubricating oil to the chain and other sliding parts regularly.  

10, in cleaning and maintenance must be disconnected from the power supply.  

11. Preparation before starting: check whether the oil level of the oil tank reaches the oil level line, refueling at each lubrication point, confirm the motor turning after starting up, check whether there is any abnormal sound of the oil pump, check whether there is oil leakage in the hydraulic system after starting up (refueling is not allowed when the Angle encoder is in the position);  

12, pressure adjustment: the electromagnetic relief valve to adjust the pressure, to ensure that the system pressure to reach the required working pressure, generally not higher than 12.5mpa.  

13, mold adjustment: mold installation, mold and clamping block center, clamping block can be adjusted by bolts;  The booster block and the mold center, the booster block is adjustable;  Core head and mold center, loosen the core head frame bolt, adjust the center and tighten the bolt.  

2. When inserting and unplugging connectors, do not pull out wires or cables to prevent welding pulling off.  

3. Proximity switches and encoders can not be hit with hard objects.  

4, can not use sharp objects collision display unit.  

5, the electrical box must be placed in a ventilated place, prohibited from working in dust and corrosive gas.  

6. Do not install or change the PC input and output terminal without permission.  

7. When changing the power supply of the machine tool, the motor must be reconfirmed.  

8, the machine should be kept clean, special attention should be paid to clamping block, slide block and other sliding groove should not have foreign bodies.  

9. Add lubricating oil to the chain and other sliding parts regularly.  

10, in cleaning and maintenance must be disconnected from the power supply.  

11. Preparation before starting: check whether the oil level of the oil tank reaches the oil level line, refueling at each lubrication point, confirm the motor turning after starting up, check whether there is any abnormal sound of the oil pump, check whether there is oil leakage in the hydraulic system after starting up (refueling is not allowed when the Angle encoder is in the position);  

12, pressure adjustment: the electromagnetic relief valve to adjust the pressure, to ensure that the system pressure to reach the required working pressure, generally not higher than 12.5mpa.  

13, mold adjustment: mold installation, mold and clamping block center, clamping block can be adjusted by bolts;  The booster block and the mold center, the booster block is adjustable;  Core head and mold center, loosen the core head frame bolt, adjust the center and tighten the bolt.