金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上

What problems will occur in the operation process of IF elbo

What problems will occur in the operation process of IF elbow machine?

Intermediate frequency bend machine 1 to 2 minutes, in the process of operating slide slowly movement 2-3 times, such as found intermediate frequency bend machine abnormal sound, should be timely parking, troubleshooting, everything is normal after the operation, the intermediate frequency bend machine is in the process of operation command, is operating with incoming personnel close cooperation, to ensure the operation of the operators and personnel feeding smoothly. If the IF elbow machine is found in the operation of the workpiece and die is not correct, should stop in time, can not touch the die directly with the hand, so as to avoid hand injury.

Intermediate frequency elbow machine, also known as stainless steel elbow machine, is to meet the market demand for stainless steel and alloy steel elbow production and development. If elbow machine can also meet the special requirements of producing carbon steel elbow. At the same time, compared with the hot push elbow machine, push machine energy saving, simple operation, high efficiency, low cost. Before pushing the elbow, the tube blank needs to be cut off with a saw. The shape of the blanking tube blank is trapezoidal, and the blanking tube blank of the hot push elbow machine is rectangular.

If elbow machine is mainly used for the formation of elbow, the main power in the operation process is hydraulic cylinder, heating method is IF heating, can be produced from 21 mm to 1620mm diameter, wall thickness from 3mm to 120mm.

If elbow machine mainly includes: base, master cylinder support plate (including master cylinder), motion push plate, front support plate, semi-active feeding structure, IF coil mediation frame (including IF heating coil), IF power supply, electrical control system, etc.