金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上

Medium frequency pipe bending machine operation process sequ

Medium frequency pipe bending machine is an advanced equipment for making curved pipes, the operation process sequence is as follows:

1. Preparation:

Confirm the specification, material and bending Angle of the pipe to be bent.

b. Clean the workbench and machine equipment to ensure that there is no debris and dirt.

c. Check the running status of the machine to ensure normal operation.

2. Install pipes:

a. Place the pipe to be bent on the work table and adjust the pipe position to align it with the positioning fixture of the bending machine.

b. Use a clamp to firmly fix the pipe on the work table to ensure that the pipe does not move or shake.

3. Set parameters:

a. Open the control panel of the medium frequency pipe bender and set the required bending Angle and radius.

b. According to the pipe material and specifications, adjust the heating and cooling time of the machine equipment.

4. Heating pipe:

a. Start the intermediate frequency heating system and move the heating coil to the required bending position of the pipeline.

b. Control the heating time and heating temperature to ensure that the pipe reaches the appropriate bending temperature.

c. Ensure that the entire surface of the pipeline is evenly heated to avoid uneven bending caused by uneven degree.

5. Bending pipe:

a. After heating, turn off the heating system and remove the pipe from the heating coil.

b. Place the pipe in the mold of the bending machine and bend according to the set Angle and radius.

c. Use the hydraulic system of the bending machine to gradually apply force to bend the pipe to the desired Angle.

d. Ensure that the pipe does not crack or deform during bending.

6. Cooling pipe:

a. After bending, remove the pipe from the bending machine and place it on the cooling table.

b. Open the cooling system and flow the cooling medium through the pipe to reduce its temperature.

c. Control the cooling time to ensure that the pipe is sufficiently cooled and maintains its curved shape.

7. Check and repair:

a. Check the appearance of the pipe after bending to ensure that there are no cracks, deformation or other quality problems.

b. If necessary, use a finishing tool to trim the pipe to the desired appearance and size.

8. Get the job done:

a. Clean the workbench and machine equipment to ensure that there is no debris and dirt.

b. Properly pack and store the completed curved pipe for subsequent use or sale.

The above is the operation process sequence of the medium frequency pipe bender. By strictly following these steps, the quality and accuracy of the bending pipe can be ensured. Be sure to pay attention to stability during operation and comply with relevant operating procedures and requirements.

For more information about medium frequency pipe bending machine, please pay attention to our website: http://www.xhxhhsl.com/