金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上

Operation procedure of automatic medium frequency pipe bende

The automatic medium frequency pipe bender is an advanced mechanical device for bending various types of metal pipes. Its operating procedure is very important, because it is directly related to the stability and production efficiency of the equipment. The following is a detailed operation procedure, including equipment preparation, operation procedures, precautions, etc.

1. Equipment preparation

1. Check the working status of the equipment to ensure that each part is intact, no noise and abnormal.

2. Check the power and air supply of the device to ensure a stable supply.

3. Check the lubrication system of the equipment to ensure that the lubricating oil is sufficient, and refuel as required.

2. Operation steps

1. Place the metal pipe to be processed on the feeding table and clamp it with a clamp.

2. Open the control panel of the device and set the bending Angle, bending radius, and bending speed as required.

3. Start the device and observe the bending process of the pipe. Note the following points during operation:

a. Ensure the close contact between the pipe and the fixture to avoid loosening or sliding.

b. Pay attention to observe the bending Angle and bending speed of the pipe, and adjust the parameters in time to maintain stability.

c. Check the lubrication system regularly to maintain the lubrication state of the equipment.

d. Pay attention to any abnormal situation during the operation of the equipment, and stop the maintenance in time.

Third, precautions

1. The operator must be familiar with the operating procedures and stability precautions of the equipment, and wear personal protective equipment.

2. Do not put your hands or other body parts near the mechanical parts during operation to avoid accidental injury.

3. Ensure that the operating environment is clean and tidy to avoid interference to the equipment caused by debris and accumulation.

4. Repair and maintain the equipment regularly to keep the equipment in good working condition.

The above is the operation procedure of the automatic medium frequency pipe bender, hoping to help you make better use of the equipment. Be sure to follow the operation procedures and ensure the stable use of the device. If you have any questions or need further help, please contact us.

For more information about medium frequency pipe bending machine, please pay attention to our website: http://www.xhxhhsl.com/