金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上,金年会 金字招牌诚信至上

The use method of bending pipe produced by bending equipment

The use method of bending pipe produced by bending equipment

1. Usage:

(1) Refer to the operation manual of electric oil pump.

(2) first screw the working cylinder into the internal thread of the square block, so that the rear end of the cylinder is mounted on the wheel on the bracket downward.

(3), choose according to bend the pipe by the outer diameter of the die set in column fortress, two roller groove which corresponds to die, and then in the corresponding size of the plate hole, then the cover plate, the curved pipe inserted into the slot, then quick joint activities of high pressure oil pipe end part of the back and set on the joint of working cylinder, to the oil drain screw tightening on the electric pump,You can bend the pipe.When the bend is finished, loosen the oil drain screw and the plunger will reset automatically.

2. Precautions:

(1) Refer to the operation manual of electric oil pump.

(2) do not unload the quick connector when there is a load.

(3) The machine is oil as the medium, the oil and the machine must do a good job of cleaning and maintenance, in order to avoid blockage or oil leakage, affect the use effect

Working characteristics of medium frequency pipe bender

When the medium frequency pipe bender is started, the careful human body shall not enter the scope swept by the rotary arm.When the intermediate frequency pipe bender happens, all the staff refrain from entering the space category of the rotary arm and pipe fitting swept!

YA-N32 ordinary hydraulic oil is accepted in the hydraulic system of the machine, which is replaced once a year under normal conditions. The oil filter must be washed at the same time.When mediating the machine tool (mould), the mediator should press the button to mediate by himself.Never one person mediates on the machine tool and the other person controls on the control cabinet.

Remove the core rod when adjusting the intermediate frequency pipe bender or running empty.Usually mechanical use after a period of time should check the chain tension level, link up and down the chain tightness is the same.

The pressure of the hydraulic system shall not be greater than 14MPa.When manually adjusting the side-pushing cylinder rate, the rotary arm shall rotate to ≥900 for mediation. The mediation rate shall be that the line rate of the edge of the elbow mold rotated by the rotary arm is synchronous. It shall be avoided that the side pushing speed is greater than the line rate of the edge of the rotary mold under manual condition.

During active manipulation in cored bending mode, the operator must ensure that the mandibular head is in the tube before the boom returns or that the mandibular head does not intercept when the boom returns, otherwise the mandibular head or mandibular head is likely to be bent or broken.After the end of the matter, the medium frequency pipe bender cut off the power supply and do a good job of clean lubrication.

2046-2045.